Bosch B4512 Installation Manual

106 en | Keypad Installer menu Control Panels
2018.07 | 16 | F.01U.287.180 Installation Manual Bosch Security Systems, Inc.
IPv6 Server Address 0.0.0.0 _______________________________
Module Hostname Blank _______________________________
DHCP/AutoIP Enable
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [1] DHCP Enable. The keypad shows the DHCP/
AutoIP current configuration.
3. Depending on the keypad model:
Press Yes or No.
-or-
Press Enter to edit the DHCP/AutoIP Enable configuration for the module. Use Previous
or Next to toggle between Yes and No..
4. Press Save or Enter. The keypad shows Parameter saved.
5. Escape from the menu.
UPnP Enable
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] UPnP Enable. The keypad shows the UPnP
current configuration.
3. Depending on the keypad model:
Press Yes or No.
-or-
Press Enter to edit the UPnP Enable configuration for the module. Use Previous or Next
to toggle between Yes and No..
4. Press Save or Enter. The keypad shows Parameter saved.
5. Escape from the menu.
20.1.6 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [2]
Address Parameters menu
IPv4 Address
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] Address Parameters > [1] IP Address.
3. Press Edit or Enter to edit the IP address.
4. Delete the existing number, if necessary, and then enter the new number. Use /
Previous or /Next to move through the different bytes.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
IPv4 Subnet Mask
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [1] Module Parameters > [2] Subnet Mask.
3. Press Edit or Enter to edit the subnet mask address.

Bosch B4512 Specifications

General

Control Panel Type	Hybrid
Wired Zones	8
Outputs	2
Programmable Outputs	2
Onboard Ethernet	Yes
Cellular Communication	Optional
Series	B Series
Partitions	2
Type	Control Panel
Model	B4512
Manufacturer	Bosch
Input Voltage	16.5 VAC
Communication Formats	Contact ID, SIA
Power Supply	16.5 VAC
Backup Battery	12 V, 7 Ah
Operating Temperature	0°C to +50°C
Weight	1.5 kg
Compatibility	Bosch accessories