Control Panels Keypad Installer menu | en 101
Bosch Security Systems, Inc. Installation Manual 2018.07 | 16 | F.01U.287.180
– Special characters. For entering special characters on B91x/B92x keypads, refer to the
following table. For entering special characters on a B93x, use the corresponding softkey.
For entering special characters or accented characters on a B94x, press or to
open the corresponding keyboard.
Characters B91x/B92x
Special dialing characters in phone numbers
(*, C [3-sec pause], D [Dial Tone Detect])
Press [CMD]. The special characters menu
appears. Use /Previous or /Next to
cycle through the characters. Press Enter to
choose the character shown.
Network address characters Use the [0] key to enter a period or dash.
*B915I keys
The B915I keypad uses the following icons, instead of words, on hard keys. All instructions in
this section refer to the word key without specifying the B915I icon.
B915 key BB915I key
[PREV] [▲]
[ENTER] [-]
[NEXT] [▼]
[ESC] [*]
[CMD] [#]
20.1 [1] Program menu (Programming)
With the Program menu (Programming Menu, you can program parameters to make your
system operational, including phone number and format, enhanced communication options,
primary and backup routes, and notifications.
20.1.1 [1] Reporting > [1] Phone menu parameters
The control panel can dial as many as four different telephone numbers when sending event
reports. In this menu, you can program the telephone numbers and the format.
Format (circle one) Phone number
Phone 1 Modem4/Contact ID ____________________________________________________
Phone 2 Modem4/Contact ID ____________________________________________________
Phone 3 Modem4/Contact ID ____________________________________________________
Phone 4 Modem4/Contact ID ____________________________________________________
Phone Number
1. Enter the installer passcode, and then go the [1] Installer Menu.
2. Go to [1] Programming Menu > [1] Reporting > [1] Phone. The keypad shows the phone
number and phone format for the phone destination.
3. Use /Previous or /Next to go to the destination you want to edit.
4. Depending on keypad model:
To Next Page
Loading...
Need help?
General
