Page 104 of 479
The Totalizer value will be logged in the report and reset to start the totalizer of next day. The
Historical report can be viewed in Event mode Report tab with the selection of Daily mode. The Weekly and
monthly report can also be viewed by changing the mode.
5.1.4 Analog Output
The Analog Output card dip switches needs to be set for required output type. The default
setting set to Voltage Output. For Current Output Set Dip Switches 1 to 5 to ON and 6 to 8 to OFF. The
below figure shows the Dip Switches setting on the AO Card.
To Next Page
Loading...
