Page 55 of 479
3.3 Pulse input through Digital input
The recorder will support pulse input up to 100Hz via digital input. The digital input can be
configured as pulse counter to count the no of pulses.
3.4 PID control with Ramp & Soak Profile function
The recorder has the option to use PID control function by using PC201 PID process control
card. The PID Control Module includes Ramp & Dwell function. It is useful to control the process with
varying set point time to time. There are 50 different Profiles can be configured with 32 Segments/Profile
with the limit of 1000 Segments totally.
3.5 On Field Calibration
The Device allows the user to do on field calibration for the device. No need to send the device
to factory for Calibration.
Note: The calibration must be carried out by a skilled person with proper instruments.
3.6 Communication with Third Party Interfaces
The Recorder has the flexibility to communicate with Third party Interfaces via protocols such as
Modbus TCP/IP or Modbus RTU as either a Modbus Master or Modbus Slave. The detailed configuration
and related information are available in Chapter 5 Configuration, and Section 5.9.
3.7 Web Server
The Recorder Trend and Digital data can be viewed in any place in the world if we have Web
Server connectivity. For this the Recorder should be connected to Internet with a fixed IP address provided
by the Internet Service provider.
3.8 Email
All Important system events and alarms can be sent as an email. The detailed configuration and
related information are available in Chapter 5, Configuration, and Section 5.9.5.
To Next Page
Loading...
Need help?
General
