Page 98 of 479
5.1.3.8.3.3 Log Event
Log as event
5.1.3.8.4 Job1 & Job2
The job is called as a task to be performed when the event is activated. There are two jobs Job1
and Job2 can be added to perform in any event.
A typical example is to trigger an alarm buzzer in the event of a high temperature. Each
channel can accept five different types of events (or alarms) and each event can create two jobs. Please
note that a job under Event is different from a job perform by Operate key. The job is actuated by an event,
and the Operate is actuated by manual control, no event necessary.
Note: Please refer to the section Jobs for full details about various jobs available
5.1.3.9 Examples for Math Channel Application
5.1.3.9.1 Example 1 with Transformation Table
A chemical tank has a non-linear shape. The level is 0 to 1400 CMS. The Recorder should
display 0 to 170 Tons as per following table
5.1.3.9.2 Example 2 with Transformation Table
The input of 0 to 20mA for pressure 0 to 150 PSIG is required to display as per the below table.
To Next Page
Loading...
Need help?
General
