Page 96 of 479
5.1.3.6.4.4 Decimal
Defines the decimal point for the Totalizer
5.1.3.6.4.5 Period
Select the period for the totalizer. The available options are Seconds, Minutes, Hours and Days
5.1.3.6.4.6 Unit
Defines the unit of totalizer
5.1.3.6.4.7 Preset
Defines the pre-set value for the Totalizer.
5.1.3.6.4.8 Low Cut
Defines the Low Cut value for the Totalizer. For example If 0.0 is set as Low cut, then, if source
channel AI1 is less than 0.0, the Totalizer value will not go to negative.
5.1.3.7 Modbus
The scaling of the channel value in Modbus communication.
5.1.3.8 Events
Events are frequently used for Alarm purposes. The events can be used to operate digital
outputs (DO), Timer, Totalizer, Counter or Report. There are maximum five events can be added to each
analog input.
Press “Add” to add new event and Press “Remove” to remove selected event
5.1.3.8.1 Type
There are various types of events are available for the user to select for job or alarm purpose.
They are listed as below.
5.1.3.8.1.1 H
It is high event. When the process value is higher than high limit, then the alarm or job
associated with this event is actuated.
To Next Page
Loading...
Need help?
General
