Page 375 of 479
To move the symbol from Left to Right, set start and end Positions for X coordinate in pixels,
there is no need to set Y coordinates.
Tag value = 0 corresponds to Start Position (X)
Tag value = 1000 corresponds to End Position (X)
Ex: Recorder 7” (High Performance), Screen Resolution = 800 X 480, Horizontal installation,
Width=800, Height=480. Move symbol from Top to Bottom in screen at Run time when tag
value changes from 0 to 100
Ex: Recorder 7” (High Performance), Screen Resolution = 800 X 480, Horizontal installation,
Width=800, Height=480. Move symbol from Left Top to Right Bottom on screen at an angle
during Run time when the tag value changes from 0 to 100
To Next Page
Loading...
Need help?
General
