CAI 700M - Page 169

700M HFID 6-2-15
169
SEMB: Set Measuring Range
Command
Response
Description
_SEMB_K0_Mn
_SEMB_s
Set measuring range to range ‘ n ‘. Auto range
will be disabled.
SENT: Set Calibration Gas Flow (Pumps or Valves)
Command
Response
Description
_SENT_K0_X
_SENT_s
x: 10 = Pump
11 = Valves
SHCG: Sets THC Mode
Command
Response
Description
_SHCG_K0
_SHCG_s
Sets the measurement mode to THC only
SMAN: Manual Control to Control Device Manually
Command
Response
Description
_SMAN_K0
_SMAN_s
Set analyzer in Manual mode.
SMGA: Start Measuring; Turn On Pumps if Fitted
Command
Response
Description
_SMGA_K0
_SMGA_s
Sets analyzer to Measure mode.
SNGA: Open Valve for Zero Gas Calibration
Command
Response
Description
_SNGA_K0
_SNGA_s
Sets to Zero Calibration mode.
_ SNGA_K0_Mn
_SNGA_s
Sets to Zero Calibration mode for Range n.
SNKA: Saves Measured Value as New Offset
Command
Response
Description
_SNKA_K0
_SNKA_s
Saves measured value of actual range as offset if
Zero mode is set.