Canmax CM-2D202 - Page 206

206
8. SERIAL PROG COMMANDS
Selection
Setting
* Indicates default
Serial Command
# Indicates a
numeric entry
Page
Primary/Alternate Data
Formats
Primary Data Format
ALTFNM0 98
Data Format 1 ALTFNM1 98
Data Format 2 ALTFNM2 98
Data Format 3 ALTFNM3 98
Symbologies
All Symbologies All Symbologies Off ALLENA0 103
All Symbologies On
ALLENA1 103
Codabar Default All Codabar Settings CBRDFT 105
Off CBRENA0 105
*On CBRENA1 105
Codabar Start/Stop Char. Transmit
CBRSSX1 105
*Not to Transmit CBRSSX0 106
Codabar Check Character. *No Check Character CBRCK20 106
Validate Modulo 16, but Not to
Transmit
CBRCK21 106
Validate Modulo 16, and
Transmit
CBRCK22 106
Codabar Concatenation *Off CBRCCT0 107
On
CBRCCT1 107
Require CBRCCT2 107
Codabar Message Length Minimum (2 - 60) *4 CBRMIN## 108
Maximum (2 - 60) *60
CBRMAX## 108
Code 39 Default All Code 39 Settings C39DFT 109
Off C39ENA0 109
*On
C39ENA1 109
Code 39 Start/Stop Char. *Not to Transmit C39SSX0 109
Transmit C39SSX1 109