Handling rolls
Clearing Jammed Roll Paper
If paper from a roll becomes jammed, Paper jam. is shown on the Display Screen of the Control Panel .
Remove the jammed paper as follows.
1. Open the Roll Cover . Use a commercially available cutter or the like to cut the paper of the
loaded roll.
Caution
• When cutting paper , be careful to avoid injury or damage to the printer .
2. Push the Release Lever back.
3. Remove the jammed paper .
• If paper is jammed inside the T op Cover
1. Open the T op Cover and move the Carriage to the left or right side manually , away from the jam.
2. Clear any jammed paper from inside the T op Cover .
After removing the paper , make sure there are no other scraps of paper in the printer .
120 Handling Paper
To Next Page
Loading...
