Network Setting (Mac OS X)
Conguring the Destination for AppleT alk Networks
(Macintosh)
T o print over an AppleT alk network, activate the AppleT alk protocol and congure the destination as follows.
Activating AppleT alk on the printer
Important
• By factory default, the AppleT alk protocol is disabled on the printer .
1. On the T ab Selection screen of the Control Panel , press ◄ or ► to select the Settings/Adj.
tab ( ).
Note
• If the T ab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press ▲ or ▼ to select Interface Setup , and then press the OK button.
4. Press ▲ or ▼ to select AppleT alk , and then press the OK button.
5. Press ▲ or ▼ to select On , and then press the OK button.
6. Press the Menu button.
If any of the settings is changed, a conrmation message is displayed. In this case, press
the OK button.
Important
• Be sure to complete step 6. This will activate the values you have entered.
Note
• By using RemoteUI , you can also specify the object name used for AppleT alk, as well as the printer
zone name.
For details on RemoteUI , see “Using RemoteUI”. (→P .569)
598 Network Setting
To Next Page
Loading...
