4-49
Sending Documents
- - - -
3 Press the one-touch key or [Coded Dial] followed by the three-digit code under
which the desired address group is registered.
If you pressed a wrong key or code, press [Clear], and perform step 3 again.
If you want to adjust the image quality and density, see “Scan Settings,” on p.
4-5.
4 Press [Start].
When <TIME OUT> is set to <ON> in <TX SETTINGS> in <FAX SETTINGS> in <TX/RX SETTINGS>, and if
you have specified the destination by any other method than using numeric keys, the machine starts
scanning automatically without pressing [Start], after the preset time for this setting is elapsed.
To Next Page
Loading...
