Access Navigator - Release 1.8 August 2003 6-5
Electrical Installation
Chassis Ground Connection
Chassis Ground Connection
Installation Summary
n Precautions ... 6-5
n Tools and Materials ... 6-5
n Run Ground Wire to Access Navigator ... 6-6
n Connect Ground Wire to Ground Lug ... 6-6
n Attach Ground Lug to Access Navigator ... 6-7
Precautions
CAUTION! CHASSIS MUST BE GROUNDED FOR COMPLIANCE WITH NEBS 1089
EMI/EMC
AND FCC REQUIREMENT PART 15, TO PREVENT RADIO FREQUENCY
INTERFERENCE WITH OTHER EQUIPMENT.
WARNING! SHEET METAL CAN BE DAMAGED BY BENDING GROUND WIRE WHEN
GROUND LUG IS ATTACHED TO ACCESS NAVIGATOR. BEFORE ATTACHING GROUND LUG
SCREWS, CAREFULLY BEND THE GROUND WIRE TO POSITION THE GROUND LUG OVER
THE REAR PANEL TERMINALS.
Tools and Materials
NOTE: A ground lug with compression terminal is provided for attaching #6 or #8 AWG
insulated stranded copper wire. Follow standard practice for building ground systems.
Obtain the following tools and materials:
• Screwdrivers, slotted
• Screwdrivers, Phillips
• Insulated copper wire, #6 or #8 AWG as required
• Wire stripper
To Next Page
Loading...