18-94 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Figure 18-23. Remote V.35 TSI Equipment Loopup
Security: Level 2 (operator)
Syntax: send remote <n> v35 tsi <equipment|network> loopup
Example: send remote 9 v35 tsi equipment loopup
Example: send remote 9 v35 tsi network loopup
Message: Loop command sent to remote.
Send Switch Provision Request
Purpose: This is a Level 1 command that allows a network manager to request ISDN CRV
provisioning information for newly configured ISDN CRVs. When RDT provisioning
is enabled at the switch, the switch will configure the D channel crossconnections. If
RDT provisioning is not enabled, the ISDN CRVs must be entered manually on both
the switch and the Access Navigator.
Security: Level 1 (manager)
Syntax: send switch provision request
Field Description
n DS1 number, 1 to 32.
equipment Loopup the equipment side
network Loopup the network side
V.35
DS1
Access
Navigator
CA FDL
Command
Access Bank II
V.35
TSI Equipment Loopup
T1
Interface
Time Slot
Interchange
Framer
To Next Page
Loading...