6-20 August 2003 Access Navigator - Release 1.8
Electrical Installation
Attach Ferrite Bead RF Suppressor
Attach Ferrite Bead RF Suppressor
CAUTION! SHIELDED RS-232 CABLE WITH FERRITE BEAD RF SUPPRESSOR IS
REQUIRED FOR COMPLIANCE WITH NEBS 1089 EMI/EMC AND FCC REQUIREMENT
PART 15, TO PREVENT RADIO FREQUENCY INTERFERENCE WITH OTHER EQUIPMENT.
1. Position ferrite bead for most convenient cable dressing and wire tying. Location is not critical.
2. Open the snap-on ferrite beads along hinge cover (see Detail A in Figure 6-10).
3. Loop RS-232 cable so that cable passes through center of ferrite bead twice (see Detail B).
4. Fold ferrite bead hinge covers together over RS-232 cable. Press covers together until they snap
together.
Figure 6-10. Attaching Ferrite Bead RF Suppressor
RS-232 CLI
Management
Connector
Shielded
RS-232
Cable
Ferrite
Bead
Detail A
Detail B
Open
To Next Page
Loading...