11-28 August 2003 Access Navigator - Release 1.8
Provision Remote Access Bank II
Connect Fractional Interface to Remote Interface
Connect Fractional Interface to Remote Interface
NOTE: The connect remote command configures the DS0 crossconnections inside
the Access Bank II, using the DS0s defined by the interface names. This produces
crossconnections between the Access Navigator DS1 drop DS0s and the Access Bank II
remote interface ports.
1. Remove old interface connection if connection must be changed with the following command:
disconnect remote <"name">
Example: disconnect remote "AcmeT1drop"
2. Connect fractional interface to remote RS-232, SDSL, T1 Drop, or V.35 interface port with the
following command:
connect remote <"name"> <rs232|sdsl|t1drop|v35>
Example: connect remote "AcmeT1" t1drop
Download Configuration to Remote Access Bank II
NOTE: When downloading remote configuration settings, the status remote
command will report “FDL tx in progress” during transmission and “FDL in service as CAC”
when transmission is complete.
Turn on remote configuration to download changes with the following command:
set remote <n> config on
Example: set remote 11 config on
To Next Page
Loading...