10-30 August 2003 Access Navigator - Release 1.8
Provision GR-303 Service
Provision DS0s to Subscribers
Provision DS0s to Subscribers
NOTE: Commands including ds0 <n:ch> require the operator to enter both the DS1
and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as
ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0
channels are separated by a hyphen.
1. Show current DS0 settings with the following command:
show ds0 <n:ch>
Example: show ds0 13:1-4
The show command will display the settings for each DS0 specified. For example, the message for
showing DS1 number 13, DS0 channels 1 to 4 would look similar to the following:
Settings for DS1 13, Channel 1:
Type: GR303
Signaling: LOOP START
Up/Down: UP
CRV: 35
PPHONE: Enabled
ISDN: None
Settings for DS1 13, Channel 2:
Type: GR303
Signaling: DID
Up/Down: UP
PPHONE: Enabled
CRV: 36
ISDN: None
Settings for DS1 13, Channel 3:
Type: DATA
Up/Down: DOWN
CRV: No CRV assigned
PPHONE: Enabled
ISDN: None
Settings for DS1 13, Channel 4:
Type: GR303
Up/Down: UP
CRV: 38
PPHONE: Enabled
ISDN: None
NOTE: In the above message, the channel type can be GR303 (voice or ISDN BRI), or
private crossconnects using VOICE or DATA. P-Phone settings only appear in the Access
Navigator / GR-303 Host with P-Phone. This procedure only provides steps for
To Next Page
Loading...