Access Navigator - Release 1.8 August 2003 13-19
Provision Remote Adit 600 via IP DS0
Provision Drop DS0s to Remote Adit
Provision Drop DS0s to Remote Adit
NOTE: Commands such as ds0 <n:ch> require the operator to enter both the DS1
and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as
ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0
channels are separated by a hyphen.
NOTE: When connected to a Nortel DMS switch, each Access Navigator can support
up to 384 P-Phone channels from up to 14 Adit 600 terminals.
1. Show current DS0 settings with the following command:
show ds0 <n:ch>
Example: show ds0 13:1-4
The show command will produce a status message for each DS1 specified. For example, the mes-
sage for DS1 number 13, DS0 channels 1 to 4 would look similar to the following:
Settings for DS1 13, Channel 1:
Type: GR303
Signaling: LOOP START
Up/Down: UP
CRV: 35
PPHONE: Enabled
ISDN: None
Settings for DS1 13, Channel 2:
Type: GR303
Signaling: DID
Up/Down: UP
PPHONE: Enabled
CRV: 36
ISDN: None
Settings for DS1 13, Channel 3:
Type: DATA
Up/Down: DOWN
CRV: No CRV assigned
PPHONE: Enabled
ISDN: None
Settings for DS1 13, Channel 4:
Type: GR303
Up/Down: UP
CRV: 38
PPHONE: Enabled
ISDN: None
To Next Page
Loading...