Carrier Access Access Navigator - Attach Access Navigator to Plywood

Access Navigator - Release 1.8 August 2003 5-17
Physical Installation
Attach Access Navigator to Plywood
Attach Access Navigator to Plywood
1. Position Access Navigator with brackets attached over screw hole locations marked in plywood (see
Figure 5-12 on page 5-20).
2. Secure mounting brackets to plywood using eight #8 × 3/4 inch panhead screws (see D in Figure
5-13 on page 5-21).
WARNING! IF ACCESS NAVIGATOR IS MOUNTED ON PLYWOOD, DO NOT USE A
HAMMER TO ATTACH PLYWOOD TO WALL BECAUSE THE IMPACT SHOCK MAY DAMAGE
THE ACCESS NAVIGATOR AND OTHER COMPONENTS MOUNTED ON THE PLYWOOD. A
POWER DRILL AND SCREWDRIVER IS RECOMMENDED TO AVOID DAMAGE.
3. Attach plywood to wall using fasteners appropriate for heavy objects.