Carrier Access Access Navigator - Analog Line Termination Objects; Alarm Count List Objects

To Next Page

To Previous Page

Access Navigator - Release 1.8 August 2003 A-5

EOC Interface

Analog Line Termination Objects

This object class is used to manage analog lines at the points where they originate or terminate. The

Access Navigator inherently creates one instance of this object class for each GR-303 DS0 on a “drop”

type DS1. The Create command can also be used to create an Analog Line Termination over the EOC.

Alarm Count List Objects

This object class contains a summary of the alarms that have not been cleared at the RDT. The Access

Navigator inherently creates one instance of this object class if the switch type is DMS. The Create

command may also be used to create an instance over the EOC.

The Create command will establish the GR-303 alarm count list at the physical location of the DS0

containing the Call Reference Value (CRV). CRVs can only be moved using CLI commands.

Table A-1 Analog Line Termination Objects

Attribute Support Command Support

Create Get Set Delete

objectClass Yes Yes

analogLineTermId Yes Yes Yes

primaryServiceState Yes Yes

secondaryServiceState Yes Yes

genSigFuncCode Yes Yes Yes

lineCircuitAddress Yes Yes

alarmSeverityAssignmentList Yes Yes Yes

Optional Attributes

callRefValue Yes Yes

redlined Yes Yes

currentProblemList Yes Yes

Table A-2 Alarm Count List Objects

Attribute Support Command Support

Create Get Set Delete

objectClass Yes Yes

alarmCountListId Yes Yes Yes

alarmCountInfo Yes Yes