18-42 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Example: log config
Displays all configuration management events.
Message:
Time Date Intf Description
---- ---- ---- --------------------------------
04:00:15 02/09/2000 SNMP System time changed to 08:02:11
04:00:35 02/09/2000 SNMP DS1 2 linecode was B8ZS, now AMI
04:00:05 02/09/2000 SNMP DS1 2 framing was SLC96, now ESF
03:34:17 02/09/2000 CLI System time changed to 04:00:00
03:32:46 02/09/2000 CLI 1:1 connected to 1:2
03:31:20 02/09/2000 CLI Switch type was 5ESS, now generic
03:30:44 02/09/2000 CLI DS1 9 fdl was none, now cac
03:30:24 02/09/2000 CLI DS1 8 termid was 0, now 5
03:29:54 02/09/2000 CLI DS0 8:24 type was VOICE, now GR303
03:29:53 02/09/2000 CLI DS1 8 loopdetect was on, now off
03:26:49 02/09/2000 CLI DS1 5 lbo was 6, now 8
03:25:37 02/09/2000 CLI DS1 5 framing was D4, now SLC96
03:25:16 02/09/2000 CLI DS1 configuration failed
03:24:39 02/09/2000 CLI DS1 5 linecode was AMI, now B8ZS
03:24:03 02/09/2000 CLI DS1 3 circuit ID modified
03:22:32 02/09/2000 CLI DS0 3:4 crv was unassigned, now 55
03:21:57 02/09/2000 CLI DS0 3:3 signaling was ls, now E&M
03:20:59 02/09/2000 ICC DS0 2:2 type was GR303, now DATAa
Description:
Item Description
Time Time of the event.
Date Date of the event.
Intf Management interface port:
CLI – Command Line Interface using RS-232 port or Telnet
Ethernet port.
EOC – Embedded Operations Channel using GR-303 DS1
interface group connected to a switch.
SNMP – Simple Network Management Protocol using Ethernet
port. (SNMP is used by MIB browsers and other
management software.)
ICC – Internal Controller Communication. The event occurred
while this Controller card was in standby.
Description Message describing the event. Messages normally give previous
and current values. A “failed” event indicates that a
configuration change was attempted but was rejected because of
command or value errors.
To Next Page
Loading...