Carrier Access Access Navigator - Set Date; Set Time

8-6 August 2003 Access Navigator - Release 1.8
Provision Access Navigator
Set Date
Set Date
NOTE: Date format is month/day/year with slashes to separate the digits, as in 01/30/
1999.
1. Show current date setting with the following command:
show date
2. If date setting is correct, skip remaining steps.
3. Set correct date with the following command:
set date <mm/dd/yyyy>
Example: set date 01/30/1999
Set Time
NOTE: Time format is 24-hour clock in hours:minutes:seconds with colons to separate
the digits, as in 08:30:45 and 15:22:10.
1. Show current time setting with the following command:
show time
2. If time setting is correct, skip remaining steps.
3. Set correct time with the following command:
set time <hh:mm:ss>
Example: set time 08:30:45
The time will be updated when you press the Enter or Return key and the Access Navigator
receives the command.