Access Navigator - Release 1.8 August 2003 12-13
Provision Remote Adit 600 via FDL
Provision Drop DS0s
Provision Drop DS0s
NOTE: Commands such as ds0 <n:ch> require the operator to enter both the DS1
and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as
ds0 6:1-12. A colon follows the DS1 number, and the beginning and ending DS0
channels are separated by a hyphen.
1. Show current DS0 settings with the following command:
show ds0 <n:ch>
Example: show ds0 13:1-4
The show command will produce a status message for each DS1 specified. For example, the
message for DS1 number 13, DS0 channels 1 to 4 would look similar to the following:
Settings for DS1 13, Channel 1:
Type: VOICE
Signaling: LOOP START (FXS)
Up/Down: UP
CRV: 113
ISDN: none
Settings for DS1 13, Channel 2:
Type: VOICE
Signaling: LOOP START (FXS)
Up/Down: UP
CRV: 114 (assigned but not available)
ISDN: none
Settings for DS1 13, Channel 3:
Type: DATA
Signaling: NONE
Up/Down: UP
CRV: 115
ISDN: B1
Settings for DS1 13, Channel 4:
Type: DATA
Signaling: NONE
Up/Down: UP
CRV: 115 (assigned but not available)
ISDN: none
2. If drop DS0 settings are correct, skip remaining steps.
To Next Page
Loading...