Carrier Access Access Navigator - Page 292

12-14 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via FDL
Provision Drop DS0s
3. Set DS0 type
set ds0 <n:ch> type <voice|data|gr303>
Example: set ds0 10:1-18 type gr303
Example: set ds0 10:19-24 type data
4. Set DS0 signaling (for voice only) to Loop Start (ls), Ground Start (gs), or E&M (em) signaling with
the following command:
set ds0 <n:ch> signal <ls|gs|em>
Example: set ds0 10:1-18 signal ls
5. Set DS0 call reference value (GR-303 or ISDN BRI only)
set ds0 <n:ch> crv <setting>
Example: set ds0 10:1 crv 120
6. Set DS0 in service
set ds0 <n:ch> up
Example: set ds0 10:1-24 up