Access Navigator - Release 1.8 August 2003 18-81
CLI Language Reference
CLI Command List
Send DS1 Off
Purpose: Stops (turns off) all qrss and prbs test patterns from the Access Navigator. This is
the default state of the system.
Security: Level 2 (operator)
Syntax: send ds1 <n> off
Example: send ds1 9 off
Send Remote Loopdown
Purpose: Sends an out-of-band (FDL) message to a remote Access Bank II over the Access
Navigator DS1 to loopdown all the remote Access Bank II interfaces. This command
is used to disable the following send remote loopup commands:
n Send Remote RS232 Line Loopup ... 18-82
n Send Remote RS232 TSI Loopup ... 18-83
n Send Remote SDSL Payload Loopup ... 18-84
n Send Remote T1 Payload Loopup ... 18-85
n Send Remote T1 TSI Loopup ... 18-86
n Send Remote T1Drop Line Loopup ... 18-88
n Send Remote T1Drop Payload Loopup ... 18-89
n Send Remote T1Drop TSI Loopup ... 18-90
n Send Remote V35 Line Loopup ... 18-91
n Send Remote V35 TSI Loopup ... 18-93
NOTE: To check remote loopback status, use the read remote loopback
command. See Read Remote Loopback on page 18-51.
Security: Level 2 (operator)
Syntax: send remote <n> loopdown
Example: send remote 9 loopdown
Message: Loop command sent to remote.
Field Description
n DS1 number, 1 to 32, or a range of numbers such as 2-8,
Field Description
n DS1 number, 1 to 32
To Next Page
Loading...