Carrier Access Access Navigator - Connect Shielded RS-232 Cable

Access Navigator - Release 1.8 August 2003 6-19
Electrical Installation
Connect Shielded RS-232 Cable
Figure 6-8. RS-232 DCE-to-DCE Modem Cable Connections
Connect Shielded RS-232 Cable
1. Connect RS-232 cable with DB9 (DE9) connector on one end to RS-232 CLI management connector
on rear panel of Access Navigator (see Figure 6-9).
2. Connect other end of RS-232 cable to the computer, craft terminal, management station, or modem.
Figure 6-9. Location of RS-232 CLI Connector
1
2
3
4
5
7
8
RS-232 DCE-to-DCE Cable
20
2
3
8
7
5
4
Access
Navigator
RS-232 CLI
Connector
(DCE)
Modem
RS-232
Connector
(DCE)
SHIELD
CTS
RTS
GND
DTR
TXD
RXD
CD
DB9
Male
DB25
(M/F as required)
(Null Modem Cable)
RS-232 Jack
(Front View)
Pin 1
Pin 9 DB9 (DE9) Female
RS-232 CLI
Management
Connector