Carrier Access Access Navigator - Set Date; Set Time

Access Navigator - Release 1.8 August 2003 6-63
Electrical Installation
Set Date
Set Date
NOTE: Date format is month/day/year with slashes to separate the digits, as in 01/30/
1999.
1. Set current date by entering the following command:
set date <mm/dd/yyyy>
Example: set date 01/30/2001
2. Show and verify date setting by entering the following command:
show date
Requirement: Access Navigator responds with correct date.
Set Time
NOTE: Time format is 24-hour clock in hours:minutes:seconds with colons to separate
the digits, as in 08:30:45 and 15:22:10.
1. Set current time by entering the following command:
set time <hh:mm:ss>
Example: set time 08:30:45
The time will be updated when you press the Enter or Return key and the Access Navigator receives
the command.
2. Show and verify time setting by entering the following command:
show time
Requirement: Access Navigator responds with correct time.