Access Navigator - Release 1.8 August 2003 15-37
Diagnostics & Troubleshooting
Send Remote RS232 Line Loopup
Send Remote RS232 Line Loopup
This command makes the remote Access Bank II perform a line loopback in the RS-232 interface. This
takes the received RS-232 data signal, loops it back in the RS-232 interface, and sends it back to the RS-
232 output. See Figure 15-13.
Syntax: send remote <n> rs232 line loopup
Figure 15-11. Remote RS-232 Line Loopup
Send Remote RS232 TSI Equipment Loopup
This command makes the remote Access Bank II perform an equipment loopback on the RS-232 signal.
This takes the received DS0 from the RS-232 equipment interface, loops it in the Time Slot Interchange
(TSI), and sends it back to the RS-232 output. See Figure 15-12.
Syntax: send remote 9 rs232 tsi equipment loopup
Figure 15-12. Remote RS-232 TSI Equipment Loopup
RS-232
Line Loopup
RS-232
DS1
Access
Navigator
CA FDL
Command
Access Bank II
T1
Interface
Time Slot
Interchange
Framer
RS-232
TSI Equipment Loopup
RS-232
DS1
Access
Navigator
CA FDL
Command
Access Bank II
T1
Interface
Time Slot
Interchange
Framer
To Next Page
Loading...