Access Navigator - Release 1.8 August 2003 15-53
Diagnostics & Troubleshooting
Other Maintenance Commands
Other Maintenance Commands
CLI Commands Descriptions
set autoexit <minutes> When enabled, the CLI session will
automatically expire if there is no user
activity during the specified time
period.
ping <ipaddr> Uses “Ping” (an Internet tool) to verify
network connections and reachability.
See Ping on page 18-45.
reset all Produces a soft reset of both
Controller cards. See Reset All on
page 18-57.
reset ds1 <n> Enables the operator to reset one or
more DS1 framers to test Loss of
Frame recovery. Reset DS1 Framer on
page 18-57.
reset remote <n> Resets a remote Access Bank II
connected to the Access Navigator
through a DS1. Reset Remote on
page 18-58.
reset standby Produces a soft reset of the standby
Controller card to verify operational
status. Reset Standby on page 18-58.
restore defaults Replaces the settings stored in the
Controller card’s flash memory with
the factory default values. Restore
Defaults on page 18-59.
switch controller Transfers active control to the standby
Controller card. Switch Controller on
page 18-176.
upload tftp config <ipaddr> <"file">
<blocksize>
Reads the Access Navigator
configuration database from flash
memory and saves the settings in file
format. See Upload TFTP Config on
page 18-176.
To Next Page
Loading...