15-12 August 2003 Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Status DS0
Status DS0
Displays the status for each DS0 specified (up to 24).
Syntax: status ds0 <n:ch>
Example: status ds0 32:1-4
Shows status of DS1 #1, DS0 channels 1 to 4. The message would look similar to the
following:
Message:
Interface Status
--------- ------
DS1 1 Channel 1 In Service
DS1 1 Channel 2 In Service
DS1 1 Channel 3 In Service
DS1 1 Channel 4 User set Out of Service
Description:
Field Description
n DS1 number, 1 to 32.
ch DS0 number, 1 to 24, or a range of numbers such as 5-8.
Item Description
Interface Lists DS1 number and DS0 channel number.
Status In Service – DS0 is up
User set Out of Service – User set DS0 down
Card Not Installed – Empty card slot
(CLI also displays alarm messages.)
To Next Page
Loading...