Carrier Access Access Navigator - Read Remote T1

18-54 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Read Remote T1
Purpose: Reads and displays the T1 settings from the remote Access Bank II at the far end of the
Access Navigator’s DS1. The Access Bank II must be operational to read its settings.
The command displays a message similar to the following.
Security: Level 3 (monitor)
Syntax: read remote <n> t1
Example: read remote 9 t1
Message:
T1 (T1#1):
CSU: On
LBO: CSU (0dB) / DSX-1 (0-133 ft.)
Linecode: B8ZS
Framing: ESF
PRM: ATT
Description:
Field Description
n DS1 number, 1 to 32.
Item Description
T1 ( ) T1 port connected to Access Navigator: T1 #1, T1 #2
CSU CSU loop code detection: On, Off
LBO CSU attenuation (dB), DSX-1 equalization (ft.)
Linecode AMI, B8ZS
Framing D4 (SF), ESF
PRM Performance report message type:
ATT – AT&T 54016 maintenance messages.
(The ATT setting is required for remote provisioning.)