Access Navigator - Release 1.8 August 2003 17-17
Update Controller Card Software
Update Software via Xmodem (One Controller)
Update Software via Xmodem (One Controller)
Procedure Summary
n Overview ... 17-18
n Precautions ... 17-19
n Information and Materials Required ... 17-20
n Verify Equipment Status ... 17-20
n Download Software ... 17-21
Overview
Xmodem Requirements
The Controller update software file must be located on a compact disk (CD), hard drive, or file
server accessible by the craft terminal or management computer through a file name or path name.
File transfers are accomplished using Xmodem protocol, which is supported by most terminal
emulation programs, such as Microsoft HyperTerminal. Using an RS-232 management session, the
operator sends a CLI “load xmodem” command to the Access Navigator. The operator then
instructs the terminal program to send the update file. Updating the active Controller will take about
30 minutes.
To Next Page
Loading...