7-4 August 2003 Access Navigator - Release 1.8
Start Management Session
RS-232 Management
RS-232 Management
RS-232 Management Requirements
A permanent RS-232 connection is normally made during installation (see RS-232 Management
Connection on page 6-17). However, a temporary cable connection can be made at any time to the
Access Navigator’s RS-232 CLI port to start a management session using a craft terminal or computer
with terminal emulation software.
The Access Navigator operating system provides a Command Line Interface (CLI), which uses simple
text based commands and messages. See Command Line Interface Conventions on page 7-3 for a short
description of the conventions used in this manual to represent management commands, settings, and
messages. For detailed information, see CLI Language Reference on page 18-1.
Procedure Summary
n Obtain Information ... 7-5
n Connect RS-232 Cable to Access Navigator ... 7-5
n Set Up Terminal Program ... 7-5
n Start RS-232 Management Session ... 7-6
n Perform Management Operations ... 7-7
n Exit RS-232 Management Session ... 7-7
To Next Page
Loading...