Access Navigator - Release 1.8 August 2003 10-31
Provision GR-303 Service
Provision DS0s to Subscribers
provisioning GR-303 service. See also Provision DCS Service on page 9-1.
2. If drop DS0 settings are correct, skip remaining steps.
NOTE: GR-303 channels use robbed-bit signaling except when carrying ISDN BRI
traffic.
3. Set DS0 type to "gr303" with the following command:
set ds0 <n:ch> type gr303
Example: set ds0 13:1-16 type gr303
NOTE: The Access Navigator/GR-303 supports GR-303 Direct Inward Dial (DID) circuit
concentration on GR-303 interface groups to switches such as the Lucent 5ESS.
(Two-way DOD/DID is not supported.) If the switch does not support GR-303 DID services,
the DID circuits can be groomed to a DS1 going to a DID shelf in the Central Office.
4. For GR-303 Direct Inward Dial (DID), set DS0 signal to "did" with the following command:
set ds0 <n:ch> signal did
Example: set ds0 13:2 signal did
NOTE: P-Phone service requires a remote Adit 600 on the drop DS1 and a Nortel DMS
switch on the switch DS1. The remote device management must be set to CAIP with the
P-Phone option enabled.
5. For P-Phone service to a remote Adit 600, set DS0 to P-Phone with the following command:
set ds0 <n:ch> pphone
Example: set ds0 13:3 pphone
To Next Page
Loading...