8-8 August 2003 Access Navigator - Release 1.8
Provision Access Navigator
Set Ethernet Properties
3. If IP address or subnet mask is not correct, enter the following command:
set ethernet ip address <address> <mask>
Example: set Ethernet address 192.168.118.65 255.255.255.0
To turn off Ethernet interface, enter
set ethernet ip address none
4. If gateway IP address is not correct, enter the following command:
set ip gateway <address>
Example: set ip gateway 192.168.118.65
If there is no gateway address, enter
set ip gateway none
To Next Page
Loading...