10-26 August 2003 Access Navigator - Release 1.8
Provision GR-303 Service
Provision ISDN BRI 4:1 TDM Service to Subscribers
2. Show current ISDN BRI settings with the following command:
show isdn crv <range>
Example: show isdn crv 1-24
The show isdn command will display the settings for each Call Reference Value (CRV)
specified. For example, the message for showing ISDN CRVs 1 to 8 would look similar to the
following:
CRV B1 B2 D
------ ------------ ------------ ------------
1 10:1 10:2 10:24
2 10:3 10:4 10:24
3 10:5 10:6 10:24
4 10:7 10:8 10:24
5 not assigned not assigned 10:23
6 not assigned not assigned 10:23
7 CRV not assigned to ISDN
8 CRV not assigned to ISDN
NOTE: The above message shows that CRVs 1 to 4 are assigned to ISDN BRI and that
their B1, B2, and D channels are connected to DS0s on drop DS1 #10.
3. If drop DS0 and ISDN BRI settings are correct, skip remaining steps.
To Next Page
Loading...