11-12 August 2003 Access Navigator - Release 1.8
Provision Remote Access Bank II
Verify System Equipment Configuration
4. Show current DS1 service status with the following command:
show ds1 all
A message similar to the following will appear, showing the link up/down service status of all DS1s
in the Access Navigator, as well as certain other parameters of common interest in trouble-shooting.
Remote
Line Term Device
Circuit ID Link Type Code Framing ID FDL Mgmt
---------- ---- ------ ---- ------- ---- ----- ------
CA DS1# 01 DOWN DROP B8ZS ESF None None
CA DS1# 02 DOWN DROP B8ZS ESF None None
CA DS1# 03 DOWN DROP B8ZS ESF None None
CA DS1# 04 DOWN DROP B8ZS ESF None None
CA DS1# 05 DOWN DROP B8ZS ESF None None
CA DS1# 06 DOWN DROP B8ZS ESF None None
CA DS1# 07 DOWN DROP B8ZS ESF None None
CA DS1# 08 DOWN DROP B8ZS ESF None None
CA DS1# 09 UP DROP B8ZS ESF None CA FDL
CA DS1# 10 UP DROP B8ZS ESF None CA IP
CA DS1# 11 DOWN DROP B8ZS ESF None None
CA DS1# 12 DOWN DROP B8ZS ESF None None
CA DS1# 13 DOWN DROP B8ZS ESF None None
CA DS1# 14 DOWN DROP B8ZS ESF None None
CA DS1# 15 DOWN DROP B8ZS ESF None None
CA DS1# 16 UP DROP AMI D4 None None
CA DS1# 17 UP DROP AMI D4 None None
CA DS1# 18 UP DROP B8ZS SLC96 None SLC96
CA DS1# 19 UP DROP B8ZS SLC96 None None
CA DS1# 20 UP DROP B8ZS ESF T1403 None
CA DS1# 21 DOWN DROP B8ZS ESF None None
CA DS1# 22 DOWN DROP B8ZS ESF None None
CA DS1# 23 DOWN DROP B8ZS ESF None None
CA DS1# 24 DOWN DROP B8ZS ESF None None
CA DS1# 25 DOWN SWITCH B8ZS ESF 1 None None
CA DS1# 26 DOWN SWITCH B8ZS ESF 3 None None
CA DS1# 27 DOWN SWITCH B8ZS ESF 4 None None
CA DS1# 28 DOWN SWITCH B8ZS ESF 5 None None
CA DS1# 29 DOWN SWITCH B8ZS ESF 2 None None
CA DS1# 30 DOWN SWITCH B8ZS ESF 6 None None
CA DS1# 31 DOWN SWITCH B8ZS ESF 7 None None
CA DS1# 32 UP GROOM B8ZS ESF None None
NOTE: In the above message, the DS1 type may be drop, groom, or switch. The
"switch" type will appear only in Access Navigator versions with the GR-303 Option. The
line termination identifier (TermID) is used only for communicating over the EOC and TMC
with the GR-303 switch.
To Next Page
Loading...