13-22 August 2003 Access Navigator - Release 1.8
Provision Remote Adit 600 via IP DS0
Provision DS0 Crossconnects
NOTE: To change existing DS0 connections, you must first disconnect them before
making new connections.
3. Disconnect existing DS0s with the following command:
disconnect <n:ch>
Example: disconnect 10:16-24
4. Connect the IP DS0 management channel on the Adit 600 drop DS1 to the IP DS0 management
channel on the Adit Router groom DS1, with the following command.
connect <n:ch> <n:ch>
Example: connect 10:24 25:10
5. Connect other DS0s (see Figure 13-3) to make 2-way connections between DS0s, or fractional
groups of DS0s, with the following command:
connect <n:ch> <n:ch>
Example: connect 10:16 18:21
Example: connect 16:17-24 21:5-12
Figure 13-3. Crossconnect Examples
connect ds0 10:16 18:21
connect ds0 12:3 17:10
connect ds0 15:7 21:4
connect ds0 16:17-24 21:5-12
DS1 #10
DS1 #12
DS0 #16
DS0 #3
DS1 #15
DS0 #7
DS1 #16
DS0 #17-24
DS1 #21
DS0 #4
DS0 #5-12
DS1 #17
DS1 #18
DS0 #10
DS0 #21
Access Navigator
Command Examples: (A)
(B)
(C)
(D)
(A)
(B)
(C)
(D)
To Next Page
Loading...