16-16 August 2003 Access Navigator - Release 1.8
Maintenance Procedures
Replace Unprotected Controller Card
Insert New Controller
1. Locate empty Controller card slot (see Figure 16-6).
Figure 16-6. Location of Controller Cards
2. Remove new Controller card from anti-static bag.
NOTE: The example in Figure 16-7 shows installation and removal of Controller B.
3. Straighten card ejector latches (see A in Figure 16-7), position new Controller card in guide rails,
and carefully slide into empty card slot.
4. Press card ejector latches in toward center of card (see B in Figure 16-7) until card connector mates
with backplane connector.
Figure 16-7. Installing and Removing Controller Card
Controller A Controller B
Card Ejector
Latches
B
A
Eject
Lock
To Next Page
Loading...