Access Navigator - Release 1.8 August 2003 16-35
Maintenance Procedures
Install SIMM on Controller Card
switch controller
13. Verify active status of upgraded Controller. The LED indicators should be as follows:
Requirement: Upgraded CONTROLLER ACTIVE/STANDBY indicator lights green.
14. Verify operational status of upgraded Controller by entering the following command:
status equipment
Requirement: Upgraded Controller status is “Active”.
15. To install SIMM on other Controller card, repeat procedure starting at Step 1.
16. End management session by entering following command:
exit
Replace Front Cover
DANGER! FIRE HAZARD. STANDARDS UL 1950 AND C22.2 NO. 950.95 REQUIRE
THAT ALL ACCESS COVERS BE REPLACED TO PREVENT FIRES FROM SPREADING TO
NEARBY EQUIPMENT.
Replace front cover and tighten screws.
To Next Page
Loading...