18-60 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
DS1 circuit identifier CA DS1 #nn = DS1 number
DS1 clock source NORMAL Uses system clock.
DS1 FDL protocol NONE Affects FDL out-of-band
BOP loop code
detection.
DS1 framing ESF Required for FDL
DS1 line loopback DOWN Disabled
DS1 line coding B8ZS Preferred for data
DS1 line buildout 1 DSX-1, 0-133 ft.
DS1 loop code detection Drop DS1: OFF
Groom DS1: ON
Switch DS1: ON
Affects CSU in-band
loop code detection.
Drop side DS1s are
normally disabled.
DS1 performance monitoring
thresholds
0 Defaults to zero
(disabled) for all
threshold intervals and
parameters
DS1 remote device management NONE Used to configure DS0
remote management
DS1 send code OFF
DS1 terminal ID
• GR-303 only
ds1 25 termid = 1
ds1 26 termid = 3
ds1 27 termid = 4
ds1 28 termid = 5
ds1 29 termid = 2
ds1 30 termid = 6
ds1 31 termid = 7
ds1 32 termid = 8
Ensures GR-303 primary
and secondary EOC and
TMC are on different
Quad DS1 Framer cards
for protection.
DS1 type
• DCS: DS1 1–32
• GR-303: DS1 1–24
• GR-303: DS1 25–32
DROP
DROP
SWITCH
DS1 up/down UP
EOC primary 25:12 Follows DS1 term ID
EOC secondary 29:12 Follows DS1 term ID
Table 18-2 Default Settings (Continued)
Parameter Default Comments
To Next Page
Loading...