Access Navigator - Release 1.8 August 2003 18-147
CLI Language Reference
CLI Command List
Syntax: show interface <"name"|all>
Example: show interface "AcmeT1"
Example: show interface all
NOTE: The first two messages below are typical for DS1 connections to a
remote port. The third message is typical for internal crossconnections from the
remote T1 Drop to another remote port.
Message:
Settings for Interface "AcmeT1"
Interface Channels: 9:13-18
Remote Port: T1Drop
Interface Type: Voice
Message:
Settings for Interface "AcmeV35"
Interface Channels: 9:19-24
Remote Port: V35
Interface Type: Data
Message:
Settings for Interface "AcmeRemote"
DS1: 9
T1Drop Channels: 11-12
Remote Port: FX
Interface Type: Remote
Description:
Field Description
name The user defined name for the interface. The name must be
enclosed in quotes.
all Display settings for all fractional interfaces.
Item Description
Interface Channels DS1 number, 1 to 32, and range of DS0 numbers such as 5-8.
(DS1 is the remote terminal number.)
Remote Port FX, RS-232, T1 Drop, V.35. (FX only applies to “Remote”
interface type.)
Interface Type Voice, Data, GR-303, Remote.
DS1 DS1 number, 1 to 32, of remote terminal.
T1Drop Channels Range of DS0 numbers on T1 Drop to be connected to Remote
Device port.
To Next Page
Loading...