1.5. Unplug the elevating motor connector.
1.5. Disassemble the lower-right B-pillar shield. (See Removal and
Installation of Door Shield )
1.6. Unplug the connector that connects the inside door harness and
in-door harness.
1.7. Unplug door contact switch connector.
1.8. Pull out the inside door harness protective rubber jacket, and
take out the harness assembly from inside the door.
2. Installation
The installation steps are reverse to those for removal.
Note: See Removal of Right-rear Door Harness for details about the
inside left-rear door harness.
To Next Page
Loading...
