Chery A113 - 2.5 Trouble Checklist without Trouble Code

Page 25 of 38
2.5 Trouble Checklist without Trouble Code
Table 1
Trouble
Evidence
The ABS warning lamp doesn’t illuminate when the engine is started
Possible Cause ● Burn of fuse
● Open-circuit of power line
● Burn of ABS warning lamp bulb
● Damage of ABS warning lamp
control
Troubleshooting
Flow
No
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Short
-
circuit?
Replace bulb
Check if warning lamp
power circuit
of ABS
harness and grounding
wire are disconnected
Replace
harness
Repair
connector
Yes
Is it normal?
Is it normal?
Does ABS
warning lamp
illuminate?
Is bulb
damaged?
Repair fuse socket
Replace fuse
Check and replace the
wiring of harness side
pin 16
Check and replace
warning lamp drive
component
Check wa
rning lamp power
circuit and grounding
circuit connector
Check if the ABS
warning lamp bulb is
damaged?
Is fuse normal?
Is socket normal?
Check ABS warning
lamp fuse in fuse box
Check fuse
socket of fuse
box
After the harness side connector
is removed, check for short
-
circuit between the harness side
pin 16 and warning lamp drive
component
Remove the harness side
connector and check the ABS
warning lamp when the entire
vehicle circuits are on.