3.2. Installation Steps
The installation steps are reverse to those for removal.
Installation notes: Is the lock column deformed? Is the riveting
adequate? Is the lock jacket on the trunk in good condition? Or can
the lock tongue open and shut freely?
4
. Removal of Trunk Lock Cylinder
4.1. Removal Steps
4.1.1. Disengage the hitch bar from the lock core.
4.1.2. Pry open the clip on the lock core with a flat head screwdriver.
4.1.3. Push up the lock core to take it out.
Note: Do not throw away the washer of the lock core.
4.2. Installation Steps
The installation steps are reverse to those for removal.
Pay attention to assemble it to its correct position and joint to door
plate work.
To Next Page
Loading...
