III. Removal and Installation of Harness
Part number: S12-3724180
Tools: flat head screwdriver, cross head screwdriver, sleeve wrench
Notes:
(1) The ignition switch must be OFF.
(2) When disassembling the electrical components and harnesses,
disconnect the power supply.
(3) When disassembling common plugs (connectors), first press
down the locking device, and then separate the plug and socket by
force. Be careful not to pull at the wires so as not to damage the
wires and connectors.
1. Removal Steps
1.1. Removal of battery and air filter.
1.1.1. Disconnect the battery negative.
1.1.2. Loosen off the battery positive and remove the battery
assembly.
1.1.3. Use a sleeve wrench to loosen off the air filter fastening nuts.
To Next Page
Loading...
