Page 35 of 38
† The union status of the sensor must be checked before the removal of the connectors
of connecting wiring (such as incomplete union, pin displacement, with impurity, and
etc.)After confirm that the sensor resistance and head are free of abnormalities,
centrally check the wiring and connectors.
② Notices for sensor checking
Case of sensor head line break arisen from over-pulling of sensor cable.
† When the connectors are removed during the checking of sensor, the instantaneous
pulling of cable under the condition that the sensor head is fixed will cause the falloff
of the internal cable of the sensor head to cause line break problem. Therefore, during
the checking of sensor, do not pull the cable with the force above the specified one.
† Sensor head cable: It may be damaged when applied with above 12kgf tension force;
Cable at connectors: it may be damaged when applied with above 4.5kgf tension force.
To Next Page
Loading...
