EasyManuals Logo

Cisco 5510 - ASA SSL / IPsec VPN Edition Configuration Guide

Cisco 5510 - ASA SSL / IPsec VPN Edition
1822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #284 background imageLoading...
Page #284 background image
9-14
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 9 Configuring Basic Settings
Setting the Management IP Address for a Transparent Firewall
Setting the Management IP Address for a Transparent Firewall
This section describes how to configure the management IP address for transparent firewall mode, and
includes the following topics:
Information About the Management IP Address, page 9-14
Licensing Requirements for the Management IP Address for a Transparent Firewall, page 9-14
Guidelines and Limitations, page 9-14
Configuring the IPv4 Address, page 9-15
Configuring the IPv6 Address, page 9-16
Feature History for the Management IP Address for a Transparent Firewall, page 9-18
Information About the Management IP Address
A transparent firewall does not participate in IP routing. The only IP configuration required for the
adaptive security appliance is to set the management IP address. This address is required because the
adaptive security appliance uses this address as the source address for traffic originating on the adaptive
security appliance, such as system messages or communications with AAA servers. You can also use this
address for remote management access.
For IPv4 traffic, the management IP address is required to pass any traffic. For IPv6 traffic, you must, at
a minimum, configure the link-local addresses to pass traffic, but a global management address is
recommended for full functionality, including remote management and other management operations.
Note In addition to the management IP address for the device, you can configure an IP address for the
Management 0/0 or 0/1 management-only interface. This IP address can be on a separate subnet from
the main management IP address. See the “Configuring General Interface Parameters” section on
page 8-22.
Although you do not configure IPv4 or global IPv6 addresses for other interfaces, you still need to
configure the security level and interface name according to the “Configuring General Interface
Parameters” section on page 8-22.
Licensing Requirements for the Management IP Address for a Transparent
Firewall
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Model License Requirement
All models Base License.

Table of Contents

Other manuals for Cisco 5510 - ASA SSL / IPsec VPN Edition

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 5510 - ASA SSL / IPsec VPN Edition and is the answer not in the manual?

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General IconGeneral
BrandCisco
Model5510 - ASA SSL / IPsec VPN Edition
CategoryFirewall
LanguageEnglish

Related product manuals