Applying Power and Verifying the Installation
Verifying the Installation ▀
ASR 5000 Installation Guide ▄
Checking the LEDs on the Ethernet Line Cards
This section describes the LEDs for the following Ethernet cards:
Fast Ethernet 10/100 Line Card (FLC2)
Gigabit Ethernet 1000 (GLC2)
Quad Gigabit Ethernet Line Card (QGLC)
10 Gigabit Ethernet Line Card (XGLC)
Each Ethernet card is equipped with status LEDs:
Run/Fail
Active
Standby
In addition to the status LEDs, each network interface is equipped with:
Link
Activity
The possible states for all LEDs on the Ethernet line cards are described in the sections that follow.
Ethernet Line Card Run/Fail LED States
The Run/Fail LEDs on the Ethernet Line Cards indicate the overall status of the cards. These LEDs are illuminated
steady green during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 64. Ethernet Line Card Run/Fail LED States
Card powered with no errors
detected
Card powered with error(s)
detected
Errors were detected during the POSTs. It is likely that the errors were logged to the
system's command line interface during the boot process.
Refer to the System Administration Guide for troubleshooting information.
Card is not receiving power
Verify that the POWER LEDs on the PFUs are green. If they are not, refer to
Checking the LED on the PFU for troubleshooting information.
Verify that the power source is supplying ample voltage and current to the chassis.
Verify that the card is properly installed per the instructions in this document.
If all of the above suggestions have been verified, it is possible that the line card is
not functional. Please contact your service representative.
To Next Page
Loading...
