Replacing Application Cards
▀ What to do with the Failed Application Card
▄ ASR 5000 Installation Guide
Step 3 Repeat step 1 and step 2 to remove the module on the replacement SMC.
Step 4 Gently insert the module removed in step 1 into the socket on the replacement SMC.
Step 5 Replace the card retainer clip to secure the CompactFlash module in place.
Step 6 Proceed to Installing the Application Card for instructions on installing the replacement SMC.
What to do with the Failed Application Card
If the failed application card is still under warranty, return it to the vendor for repair.
If the failed application card is out of warranty, contact Cisco to determine if it can be sent in for repair at an additional
cost.
Important: Disposal of this product should be performed in accordance with all national laws and regulations.
Refer to the support area of http://www.cisco.com for up-to-date product documentation pertaining to installation,
configuration, and maintenance. A valid username and password is required to use this site. Please contact your local
sales or service representative for additional information.
Important: For additional information on the RMA process, see the RMA Shipping Procedures appendix.
To Next Page
Loading...
